McCulloch ROB S600 Operator's Manual page 11

2. Push the ON/OFF button for 3 seconds and make
sure the product is switched off. Check that the
indicator lamp on the keypad is not lit. This means
that the product is disabled. Refer to
lamp on page 26 .
3. Carry the product by the handle with the blade disc
away from the body.
2.3.4 Maintenance
WARNING:
switched off before maintenance is done.
The product is disabled when the indicator
lamp on the keypad is not lit.
1411 - 007 - 23.09.2020
The indicator
The product must be
WARNING:
the charging station before cleaning or
maintenance of the charging station or the
loop wire.
CAUTION:
Do not use a high-pressure
washer to clean the product. Do not use
solvents for cleaning.
Examine the product weekly and replace damaged or
Maintenance on page 29 .
worn parts. Refer to
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical components
in the product and the charging station, we recommend
that all connections to the charging station are
disconnected (power supply, boundary wire and guide
wire) if there is a risk of a thunderstorm.
1. Mark the wires to simplify reconnecting. The
charging station's connections are marked R, L
and GUIDE.
2. Disconnect all connected wires and the power
supply.
3. Connect all the wires and the power supply if there
is no longer a risk of thunder. It is important that
each wire is connected to the right place.
Use the plug to disconnect
Safety - 11