McCulloch ROB S600 Operator's Manual page 23

Function Low
Alarm
PIN-code
Time lock
X
• Alarm - An alarm goes off if the PIN-code is not
entered within 10 seconds after the STOP button is
pushed. The alarm also goes off when the product
is lifted. The alarm stops when the PIN-code is
entered.
PIN-code - The correct PIN-code must be entered
•
to get access to the Menu structure of the product.
If the incorrect PIN-code is entered 5 times, the
product is locked for a time. The lock is extended
for each new incorrect try.
Time lock - The product locks if the PIN-code has
•
not been entered in 30 days. Enter the PIN-code to
get access to the product.
3.10.5.1 To set the security level
Select 1 of the security levels for your product.
To get access to the menu on
1. Do steps 1–3 in
page 21 .
2. Use the arrow buttons and the OK button to move
through the menu structure
Security level .
3. Use the arrow buttons and the OK button to select
the level of security.
4. Push the OK button.
3.10.5.2 Security - Advanced
To make a new loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to make a new signal,
for instance if two adjacent installations have very
similar signals.
1. Put the product in the charging station.
2. Do steps 1–3 in To get access to the menu on
page 21 .
3. Use the arrow buttons and the OK button to move
through the menu structure
Advanced > New loop signal .
4. Wait for confirmation that the loop signal has been
made. This usually takes about 10 seconds.
To change the PIN-code
To get access to the menu on
1. Do steps 1–3 in
page 21 .
2. Use the arrow buttons and the OK button to move
through the menu structure
Advanced > Change PIN-code .
3. Enter the new PIN code.
4. Push the OK button.
1411 - 007 - 23.09.2020
5.
Medium High
6.
X
7.
X X
3.10.6 Lawn Coverage
X X
The
product to remote parts of the work area. If the work
area includes remote parts that are connected with
narrow passages, the
maintains a well-cut lawn in all parts of the yard. You
can set the frequency of how often the product starts to
follow the guide wire to mow in the connection with the
boundary wire. If the
used, the product starts to mow from the charging
station.
3.10.6.1 To set the Lawn Coverage function
1.
2.
3.
Settings > Security >
Settings > Security >
4.
3.10.6.2 To do a test of the Lawn Coverage function
1.
2.
Settings > Security >
3.
4.
Enter the new PIN code again.
Push the OK button.
Make a note of the new PIN code. Refer to
Introduction on page 3 .
Lawn Coverage function is used to guide the
Lawn Coverage function
Lawn Coverage function is not
To get access to the menu on
Do steps 1–3 in
page 21 .
Use the arrow buttons and the OK button to move
Settings > Installation
through the menu structure
> Lawn Coverage > Area 1 .
Use the arrow buttons to select the % of the cutting
time the product must cut the area. The % is equal
to the % of the area in relation to the complete
work area.
a) Measure the area.
b) Divide the area with the work area.
c) Convert the result to %.
60%
1
Push the BACK button.
Put the product in the charging station.
To get access to the menu on page
Do step 1-3 in
21 .
Use the arrow buttons and the OK button to move
Settings > Lawn
through the menu structure
Coverage > Area 1 > More > Test .
Push the OK button.
2
Installation - 23