Matrox Maevex 5100 Series Release Notes page 8

 Windows 10/7 – If your controller system doesn't have access to a DNS
server or if response from its DNS server is slow, PowerStream Plus may take
a long time to start up (several minutes). To avoid this delay, configure your
controller system to use a fixed IP address (such as local host – 127.0.0.1) as
its DNS server.

To ensure compatibility with auto-negotiating network switches and routers,
your Maevex devices use auto-negotiation for their network speed and duplex
settings. We recommend you configure the networking hardware your
Maevex product is connected to so that it also auto-negotiates these settings.
We also recommend you make sure the speed and duplex settings of your
Maevex devices and networking hardware match. If image corruption occurs,
make sure your networking hardware (and the ports connected to your
Maevex devices) isn't overloaded and dropping data packets. If necessary,
increase the bandwidth allocated to the ports connected to your Maevex
devices, or try using different ports.

Connecting a networked device other than a Maevex decoder (such as a
computer, networked display, etc.) to the second network port of a Maevex
decoder is currently unsupported.
 If you're using
system may not output a valid signal, making capture impossible. To resolve
this issue, we recommend trying one of the following:



Updating the firmware in parallel while your decoder devices are daisy
chained isn't supported. Decoder devices that are daisy chained must be added
to the Firmware Update Utility's list of devices to update and updated one
device at a time.
P owerStream Plus SDK and REST APIs
1 2 B
For more information on the Matrox PowerStream Plus SDK and REST APIs, or to
obtain a version (Windows
Support (www.matrox.com/en/video/forms/products/maevex-developer-tools).
Release Notes – Matrox
®
8 Matrox
Pass through
Use
Confidence preview
Connect a local monitor to a Maevex encoder's local output (
) before enabling the
OUT
®
or Linux
Maevex™ 6100 Series and Maevex™ 5100 Series
®
mode without a local monitor present, the source
mode instead of
Pass through
®
) of the SDK, contact Matrox Technical
mode.
Pass through
mode in PowerStream Plus.
HDMI