Matrox Maevex 5100 Series Release Notes page 3

Remove the older (previously installed) version of Matrox PowerStream
3
software.
PowerStream Plus automatically detects the Maevex devices that are on the same
subnet as PowerStream Plus, and adds them to your environment. You'll need to
manually add any devices that remain undetected.
For more information, see the Matrox PowerStream Plus user guide. Matrox makes
the latest PowerStream Plus software and firmware package available on the Matrox
web site ( www.matrox.com/maevexsw
H
D owngrading your PowerStream Plus version
9 B
Note: This is not applicable to the use and control of the Maevex 6152
decoder.
 If a password that's longer than 8 characters is set, older PowerStream or
PowerStream Plus versions (previous to 2.01.03) won't be able to authenticate
these devices. Before downgrading your version of PowerStream Plus
software, we recommend first changing the password to set a password that's
between 6 and 8 characters long. For more information on changing
passwords, see the Matrox Maevex User Guide.

If downgrading PowerStream Plus software to 2.00 (not recommended),
certain user settings related to version 2.00 (like the device tile organization)
won't be automatically restored. For more instructions on downgrading,
contact Matrox Technical Support.
D owngrading to an older version of the firmware
5

Firmware downgrading is limited to version 2.02.01.017 (which also supports
the TLS1.2 protocol). To downgrade to an older firmware version (which uses
the TLS1.0 protocol), downgrade first to version 2.02.01.017, and then
downgrade further. Note: This is not applicable to the Maevex 6152 decoder.

Maevex 6100 Series Encoders – Firmware downgrading to version
2.02.01.017 is supported only from the default IP mode
from
IPv4
supports only IPv4.
®
Matrox
. Downgrading from
Release Notes – Matrox
) .
H
isn't supported, because the 2.02 release
IPv6
Maevex™ 6100 Series and Maevex™ 5100 Series
®
and
IPv4 and IPv6
3