N Otes And Limitations - Matrox Maevex 5100 Series Release Notes

N otes and limitations

7
M aevex 6100 Series Encoders
1 0

Following an input signal interruption or switching, the
on signal loss
mode or signal frequency change. In the event of an input mode change, the
outgoing stream will be torn down and regenerated, resulting in a decoder
disconnect and reconnect event.
 Can't record to an IPv6 link-local address. [1791]

HLS has a limited and fixed list of frame sizes. For more information, contact
your Matrox representative [1691].

RTMP push streaming to Wowza
authentication.

Depending on the analog audio input voltage level from the analog audio
source, clipping (audio distortion) may occur in the stream and headphone
out, especially at higher or maximum (6dB) audio input level setting from
PowerStream Plus. To avoid this, reduce the analog audio level from the
source, from PowerStream Plus, or from both.

Recording to extFS (ext2/3/4), NTFS, and FAT32 drives is supported
(exFAT-formatted drives aren't supported).

Before recording to a networked shared drive or folder, make sure you have
the appropriate user rights and credentials to do so. Different operating
systems have different ways to share folders, so make sure the share is set up
accordingly (for example, some Windows operating systems require a user
name and password setup for the share folder to be accessible).

HDCP (High-Bandwidth Digital Content Protection) is not supported in this
release.
 Windows Server 2019, Windows Server 2016, and Windows 2008 R2 –
Windows Server operating systems disable the SSDP Discovery service by
default. For your devices to be automatically detected on your subnet, this
service needs to be enabled. For more information on enabling this service,
see Windows documentation.

Multicast streaming requires networking hardware that supports multicast and
is properly configured for multicasting. Otherwise, only unicast streaming
will be supported.
1
Tracking reference number
Release Notes – Matrox
®
4 Matrox
feature requires that the input signal recover without an A/V
®
Maevex™ 6100 Series and Maevex™ 5100 Series
®
1
Cloud is supported only with no
Continue streaming