Table of Contents
Advertisement
Change Current Date
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Configure Hold Time
Hold Time is the length of time that all Timed Hold conditions will remain,
until the schedule resumes normal operation. Hold Time is set to 120
minutes by factory default to comply with energy conservation standards.
You may change the Hold Time to any value from 10-360 minutes, in 10
minute increments.
Step 1:
Step 2:
Step 3:
Set Flick Warn
Flick Warn is a feature that provides visual warning to occupants in a space
when the next pending scheduled event is intended to turn all of the lights
off. The E-ATC will flash the lights on and off for a set length of time before
the pending event occurs, allowing a user to either issue a Hold command,
or use manual lighting control to issue an Auto Timed Hold. The amount of
time before Flick Warn activates is determined by the Warn Time setting
within the Timeclock Settings menu. This setting applies to all scheduled
events.
Step 1:
Step 2:
Step 3:
20
Select Date from the Timeclock Settings menu.
Press [Enter] to modify the current selection. The Month
field will display selected.
Use the [Up] or [Down] buttons to scroll to the current
month and press [Enter]. The Day field will display selected.
Use the [Up] or [Down] buttons to scroll to the current day
and press [Enter] to select a new date. The Year field will
display selected.
Use the [Up] or [Down] buttons to scroll to the current year
and press [Enter] to select a new year.
Select Hold Time from the Timeclock Settings menu.
Press [Enter] to modify the current selection.
Use the [Up] or [Down] buttons to scroll to the desired Hold
Time and press [Enter].
Select Flick Warn from the Timeclock Settings menu.
Press [Enter] to modify the current selection.
Use the [Up] or [Down] buttons to scroll and select either
Yes or No, then press [Enter] to confirm the current
displayed selection.
Echo TimeClock Configuration Manual
Advertisement
Table of Contents
