Install The Faceplate - ETC Unison Echo Astronomical TimeClock Configuration Manual

Step 2:
Step 3:
Step 4:

Install the Faceplate

The faceplate is secured to the station with built-in magnets.
Step 1:
Step 2:
Step 3:
Step 4:
12
Use spacers as needed to provide a flush mounted station.
a: Fold the spacer in a zig-zag fashion and press the stack
together to achieve the thickness needed to fill the gap
between the station, wall surface, and the back box.
b: Cut off and discard the excess.
c: Place the stack between the station electronics and the
flush mounted back box.
Secure the station in place using the four screws provided.
Using a level, align the E-ATC perfectly square to the walls.
If the station is not installed level and flush, the faceplate
will not fit properly to the unit or against the wall. Refer to
step 2 for information regarding use of the provided
spacers to mitigate flush mount issues.
Align the top of the faceplate to the station and angle the
bottom approximately 20 degrees.
Hook the top of the faceplate to the tabs located on the
electronics assembly. To ensure the faceplate is hooked
properly on the top hook, wiggle it slightly side to side.
Swing the bottom of the faceplate down until the magnets
engage.
If the faceplate does not fully attach automatically, wiggle
the bottom of the plate until the magnets are seated
properly to the station nd the plate is secure.
Echo TimeClock Configuration Manual