Mobile Operation; Base Station Operation - Midland I3-795 Owner's Manual

1. USE 12 NICKEL-CADMIUM RECHARGEABLE BATTERIES (1.25 VOLTS EACH)
1. Extend the antenna to its füll length or connect an external antenna.
NOTE: Transmitting without any antenna may damage the output transistors.
2. Turn the volume/on-off switch to the on position.
3. Check the meter to be sure your batteries are good.
4. Set the channel selector to the desired channel.
5. Adjust the volume and squelch Controls.
6. To transmit, press and hold the push-to-talk bar and talk into the speaker/mike
grill. Use a normal tone of voice and hold the unit about 2 to 3 inches from
your mouth. To receive, release the push-to-talk bar.
For best transmission and réception when using the built in antenna, it should be
held in a vertical position.

MOBILE OPERATION

This unit may be used in a vehicle, drawing its power from the car or boat battery
system and using a mobile antenna installed on the vehicle. However, this unit is
designed to operate from 15 volts DC and slightly reduced performance may be
noticed when using a 12 volt supply system.

BASE STATION OPERATION

This unit may also be used as a base station with a suitable base station antenna.
B A T T E R Y IN S T A L L A T IO N FO R N IC K E L -C A D M IU M B A T T E R IE S
12 SERIES-CONNECTED BATTERY CELLS
(EACH TUBE HOUSES 2 CELLS)