Hide thumbs Also See for I3-795:

Advertisement

Quick Links

ülDLAND
COM IVIUfSIIC/VTIОISJS COM PANY

Advertisement

Table of Contents
loading

Summary of Contents for Midland I3-795

  • Page 1 ülDLAND COM IVIUfSIIC/VTIОISJS COM PANY...
  • Page 2 Your new Midland 13-795 is a combination receiver-transmitter designed and built for licensed Class'D* operation on any of the 23 frequencies designed as citizens band channels by the Federal Communications Commission. You are required to read and understand Part 95 of the F.C.C. rules and régulations prior to operation of this unit.
  • Page 3: Channel Selector

    CHANNEL SELECTOR Controls both transmitter and receiver frequencies simultaneously and may be set to any of the 23 positions indicated. All necessary crystals are supplied for full 23 channel operation. VOLUME/ON-OFF Turns the set on and Controls the sound output from the speaker when receiving. The volume control does not affect transmitting output.
  • Page 4: External Power Jack

    CHARGE JACK Permits recharging of rechargable batteries without removal from the case. EXTERNAL POWER JACK Permits Use of an external 15 volts DC supply. (SEE MOBILE AND BASE OPERATION) EXTERNAL SPEAKER JACK Permits the use of an external 8 ohm speaker. When the external speaker is plugged in, the speaker in the set is disconnected in the receive position.
  • Page 5: Battery Installation

    BATTERY INSTALLATION À When replacing batteries, turn power switch off. Note: This transceiver opérâtes from 15 volts DC and may be powered by 12 1.25 volt nickel cadmium rechargable cells or 10 1.5 volt regulär " A A " type penlight cells. When using penlight cells, 2 dummy batteries (sup- plied) must be used.
  • Page 6: Mobile Operation

    B A T T E R Y IN S T A L L A T IO N FO R N IC K E L -C A D M IU M B A T T E R IE S 1. USE 12 NICKEL-CADMIUM RECHARGEABLE BATTERIES (1.25 VOLTS EACH) 12 SERIES-CONNECTED BATTERY CELLS (EACH TUBE HOUSES 2 CELLS) 1.
  • Page 7: Specifications

    SPECIFICATIONS Circuit system Receiving section Crystal controlled dual conversion superheterodyne with RF amplifier füll variable squelch and noise limitter. Transmitting section Crystal controlled oscillation, collector modulation system. Semi-conductor 16 Transistor plus 1 Transistor in squelch circuit. 1 Zener Diode 5 Diodes 1 Thermistor 1 Varistor 27 MHz citizen band synthesized system...
  • Page 8: Service Information

    F.C.C. unless you hold a first or second dass radiotéléphone license or are in the presence of a person holding such a license. A Citizens Band or Amateur license is not sufficient. MIDLAND COMMUNICATIONS COMPANY HEREBY CERTIFIES THAT THIS UNIT HAS BEEN DESIGNED AND MANUFACTURED IN ACCORDANCE WITH VOL. 6, PART 95 OF THE CURRENT FCC RULES AND REGULATIONS AS OF THE DATE OF MANUFACTURE.
  • Page 9: Adjustment Guide

    ADJUSTMENT GUIDE Caution: The antenna must be fully extended, or a suitable load applied when transmitting or the output transistors may be damaged. Transmitting section 1. Set the channel selector to channel 13. 2. Connect an RF power meter to the external antenna jack. (Antenna with- drawn).
  • Page 10 Г ■ , - ■ ■ ■ ■ — — FREQUENCY SYNTHESIZER CRYSTAL COMBINATION LIST (A) Group 6 pcs. (B) Group 4 pcs. (C) Group 4 pcs. (Receiving) (Transmitting) a" :6.490 MHz 33.000 MHz a' :6.035 MHz 33.050 MHz b' :6.025 MHz b"...
  • Page 11: Schematic Diagram

    SCHEMATIC DIAGRAM...
  • Page 12: Warranty Policy

    This warranty shall not apply to any Midland product which has been subject to misuse, neglect, accident, incorrect wiring not of our own installation, or to use in violation of instructions furnished by us, nor extended to units which hâve been...

Table of Contents