Shenzhen Xunlong Software Orange Pi Plus User Manual page 11

Orange Pi Plus User Manual
writing.
Linux:
1. Insert your TF card into your computer. The size of TF should be
larger than the OS image size, generally 4GB or greater.
2. Format the TF card.
fdisk –l
i. Run
umount
ii. Run
sudo fdisk
iii. Run
command to delete all partition of TF card and use
add one new partition. Use
sudo mkfs.vfat /dev/sdx1
iv. Run
partition of TF card as FAT32.
(x should be replaced according to your TF card node)
You can also jump this step under Linux, because write image command
dd
under Linux will format the TF card automatically.
3. Download the OS image from the Downloads webpage.
i. Website:http://www.orangepi.org/downloaded/download.html
4. Unzip the download file to get the OS image
android os image need other burn
unzip [downloaded filename]
i. Run
5. Write the image file to the TF card.
fdisk –l
i. Run
ii. Verify if the hash key of the zip file is the same as shown on the downloads
page (optional).
sha1sum [path]/[imagename]
This will print out a long hex number which should match the "SHA-1" line
for the TF image you have downloaded
iii. Run umount
iv. Run sudo dd bs=4M
file to TF card. Wait patiently to successfully complete writing. Please note that block
size set to 4M will work most of the time, if not, please try 1M, although 1M will take
considerably longer.You can use sudo pkill –USR1 –n –x dd command to check
progress
www.orangepi.org
/dev/sdx
command to check the TF card node.
/dev/sdxx
to unmount all the partitions of the TF card.
/dev/sdx
command to configure TF card. Use
/dev/sdx
command to check the TF card node.
/dev/sdxx to unmount all the partition of the the TF card
if=[path]/[imagename] of=/dev/sdx
Shenzhen Xunlong Software CO., Limited
w
command to save change.
command to format the new created
(exclude android os image,
mode).
command.
o
n
command to
command to write image
www.xunlong.tv