ENGLISH 5.3 OVEN PREPARATION ........Page GB-19 5.3.a General rules to bake on refractory CHAPTER ..........surfaces ..........Page GB-19 5.3.b General rules to bake in baking-tin ..Page GB-19 Chapter for the technician and operator 1.1 GENERAL WARNINGS ........Page GB-3 5.3.c Oven starting ..........
MILLENNIUM MM/MB General specifications and warning Chapter 1 1.1 - GENERAL WARNINGS - The oven shall not be left unguarded. - Wear safety clothing only, approved by the law in force. - Before starting the oven, user shall carefully read this handbook and be aware of both technical specifications - In case of works to be done in a position that cannot be and control elements.
MILLENNIUM MM/MB General specifications and warning - THESE SAFETY REGULATIONS INTEGRATE OR COMPLEMENT THE LOCAL SAFETY REGULATIONS. - NEVER carry out hasty or makeshift repairs which could jeopardize the oven functioning and user’s safety, as well. ATTENTION - IN CASE OF DOUBT ALWAYS ASK FOR THE PRESENCE This symbol is used in the safety messages of the OF SKILLED PERSONNEL.
MILLENNIUM MM/MB General specifications and warning 1.6 - EMERGENCY OPERATIONS IN CASE OF 1.5 - PREARRANGEMENTS AT PURCHASER’S FIRE CHARGE a) Prearrangement of the installation place. a) In case of fire, disconnect the oven by disconnecting • The supporting surface the oven shall be placed on the cutout switch.
MILLENNIUM MM/MB Technical data - Transport and unpacking 2.2 - TRANSPORT FIG. 1 FIG. 1 2.2.a - Shipment (Fig. 1) The oven is positioned on a wooden pallet being fixed by means of screws and put into a box equipped with strapping.
MILLENNIUM MM/MB Technical data - Transport and unpacking 2.3 - RECEPTION OF THE MACHINE FIG. 3 Upon reception of the machine make sure that the packing is complete and not damaged. Should the packing be complete, remove it as specify at point 2.4 (aside from different manufacturer’s instructions).
MILLENNIUM MM/MB Technical data - Transport and unpacking 2.5 - IDENTIFICATION OF THE COMPONENTS 2.6 - OVEN IDENTIFICATION (Fig 4) (Fig. 4) Both serial number and oven identification data are engraved on a plate (7) being fixed on the base of the 1.
MILLENNIUM MM/MB Installation and connections Chapter 3 FIG. 1 DANGER All operations described in this chapter shall be carried out by skilled and authorized technicians, only. 3.1 - OVEN LIFTING (Fig 1) The oven lifting shall be carried out by using a crane or a tackle as follows: •...
Page 14
MILLENNIUM MM/MB Installation and connections FIG. 3 Two-, three-chamber oven assembling (Fig 3) (For 430-435 models, only) • To assemble the two-chamber oven, position the second oven (7) the first oven (6) and fix it by the small bracket (8) and the screws (9). •...
MILLENNIUM MM/MB Installation and connections FIG. 7 3.3.b - Electric hood connection Concerning electric hood connection, follow the instructions supplied with the hood. 3.3.c - Unipotential connection (Fig 7) The equipment shall be inserted in a unipotential system, whose effectiveness shall be verified according to the rules being in force.
MILLENNIUM MM/MB Safety devices Chapter 4 4.1 - TYPE OF USE AND CONTRAINDICATIONS FIG. 1 IMPORTANT MILLENNIUM MM/MB ovens are professional machines suitable for baking pizza and similar products. The various models shall only be used to process as above; in case of any other use, manufacturer disclaims all responsibility for accidents to persons or objects and customer will be debarred from a possible guarantee right.
MILLENNIUM MM/MB Safety devices FIG. 2 4.3 - SAFETY DEVICES (Fig 2) The equipment is equipped with following safety systems: 1) All dangerous areas are closed by screwed cases. 2) Each oven is equipped under the right-hand panel with a safety thermostat (1) to allow the oven to be disconnected in case of overtemperature inside the baking chamber.
MILLENNIUM MM/MB Functioning Capitolo 5 5.1 - CONTROL BOARD AND PILOT LIGHTS ON DIGITALLY CONTROLLED OVENS (Fig 1) FIG. 1 On the oven, there are the following control elements: 6. Bedplate resistance capacity Pressing it, the connection percentage value of the 1.
MILLENNIUM MM/MB Functioning 5.2 - MANUAL OVEN CONTROL BOARD (Fig 2) FIG. 2 On the oven, there are the following control elements: 6. Increment key To increase the temperature value. 1. Line key ON/OFF 7. Decrement key Pressing it, the display (2) lights up and the control To reduce the temperature value.
MILLENNIUM MM/MB Functioning 5.3 - OVEN PREPARATION 5.3.b General rules to bake in baking-tin • Heat up the oven at least one hour and fifteen minutes Pizza can be baked either directly on the refractory oven before starting the work and set following parameters: surface or in the baking-tin.
Page 22
MILLENNIUM MM/MB Functioning FIG. 3 5.3.c - Oven starting (2) (Fig: 3) • Close the chimney by positioning the handwheel (A) to close the damper. • Press the key , the display (1) lights up. • On the display (1) the real oven temperature is displayed.
MILLENNIUM MM/MB Functioning FIG. 4 5.4 - PIZZA BAKING • When the set temperature is reached, open the chimney damper by positioning the handwheel on open the access door and insert the pizza to be baked. ATTENTION Inside the oven, temperature is very high, therefore suitable individual protection means shall be used to insert and remove the pizza;...
MILLENNIUM MM/MB Functioning FIG. 5 5.6 - SELF-CLEANING CYCLE (Fig 5) • At the end of each working day, a self-cleaning cycle shall be carried out before cutting off the oven. • Press the key and operate the key to reach a 400°C temperature. •...
MILLENNIUM MM/MB Functioning 5.8 - MALFUCTIONING,CAUSE AND CURE FIG. 6 The oven does not start: • Verify the electric connection. • Make sure the cutout switch is on. • Contact manufacturer’s technical service. Pizza is not baked, uniformly: • The baking surface is dirt: clean the baking surface •...
MILLENNIUM MM/MB Maintenance Chapter 6 6.1 - ROUTINE AND PLANNED MAINTENANCE 6.1.b - Ordinary maintenance 6.1.b.a - Outer cleaning (to be carried out every day) 6.1.a- In general ATTENTION DANGER At the end of each working cycle, carefully clean the oven.
MILLENNIUM MM/MB Maintenance 6.1.c - Planned maintenance FIG. 2 6.1.c.a - Every 600 hours a careful chamber cleaning (Fig 2) • Make sure the oven is totally cool, then open the door, remove the protection (1) unscrewing the relevant screws and gently take off the refractory surface (2) from the door.
MILLENNIUM MM/MB Maintenance 6.1.d.b - Lamp replacement (Fig 4) FIG. 4 • Unscrew the glass (1) protecting the lamp (2). • Unscrew theburnt out lamp (2) and replace it, then reassemble all by proceeding in the opposite way. 6.1.d.c - Ceiling or bedplate resistance replacement FIG.
MILLENNIUM MM/MB Maintenance FIG. 6 6.1.d.d - Door spring replacement (Fig 6) DANGER This operation shall be carried out by skilled technicians. • Remove the right-hand panel (1) by unscrewing the relevant screws. • Remove the control board (2) by unscrewing the relevant screws.
MILLENNIUM MM/MB Maintenance FIG. 7 6.1.d.e - Door pane replacement (Fig 7) DANGER This operation shall be carried out by skilled technicians. • Open the door (1) and remove the inner panel (2) loosening the relevant screws (3). • Replace the pane (4) and mount all again proceeding in the reverse.
MILLENNIUM MM/MB Dismantling - Demolition - Disposal Chapter 7 7.1 - OVEN DISASSEMBLY In case the oven shall be disassembled to reinstall it ATTENTION later, proceed in a reverse order compared to the Consult the next paragraph when disposing of description being reported in “Installation”...
Need help?
Do you have a question about the MILLENNIUM MM Series and is the answer not in the manual?
Questions and answers