Table of Contents
Advertisement
2.6 PUTTING ON THE FREEWHEEL BODY AND THE END CAPS
1. Put the freewheel body onto the hub.
2. Check if the freewheel body can be turned
and if the ratchets are engaging.
3. Grease both bearings and the inner side of
both end caps.
4. Put on the left and the right end cap.
→ The shorter end cap must be placed on
the drive side.
2.7 CHECK THE FUNCTIONALITY
1. Turn the freewheel body in both directions.
→ The freewheel body can be turned
counterclockwise easily.
The ratchets engage audibly and
perceptibly.
→ The freewheel body cannot be turned
clockwise.
2. Check the tightness of the end caps.
→ The end caps are firmly seated on the
axle and are fully pushed on.
Closing Steps:
Mount the brake rotor
Assembling the cassette
Clean the hub
Cross reference / Note
see manufacturer's instructions
see manufacturer's instructions
Ratchet EXP - Maintenance of the freewheel system
11
Advertisement
Table of Contents
