Table of Contents
Advertisement
2-4-4
Flash Duration Analysis Radio Triggering Mode
The meter detects flash brightness after Measuring Button is pressed to send radio
transmitted signal to radio receiver connected to flash. F-stop, flash duration time and
graph of flash waveform are displayed for input ISO sensitivity and shutter speed.
Depending on the receivers in use, the meter controls the output power of flash units
and modeling lamp with turning ON/OFF, however, flash duration time and graph of
flash waveform are not measured in Modeling Lamp Power Control Screen because it is
ambient light not flash light.
Flash Duration Analysis is performed with Incident Light Measuring Mode.
Operation
1)
How to use Flash Triggering
1.
Touch the [Measuring Mode] Icon on the Measuring Screen.
The Measuring Mode Screen is displayed.
2.
Touch the [Flash Duration Analysis Radio Triggering Mode] Icon
(
) in Measuring Mode Screen.
When it is selected, the display changes to the Measuring Screen.
The Flash Duration Analysis Radio Triggering Mode can be selected only when the
incident light is set in the meter.
[Measuring Screen]
[Measuring Mode] Icon
3.
Set the light receiving method.
Switch to the extended lumisphere (
[Measuring Mode Screen]
)
or retracted lumisphere (
35
2. About Godox Radio System
[Measuring Screen]
).
●
Advertisement
Table of Contents
