Table of Contents
Advertisement
2-4-2
Radio Triggering Multiple (Cumulative) Flash Mode
This Measuring Mode is used when the light generated by the flash at one time is
inadequate for the desired F-stop setting. Repeated flash pops can be accumulated until
the desired F-stop value is displayed. The measured value (F-stop) is displayed for each
trigger of the flash. The cumulative count is infinite. Up to 99 times is displayed in the
Status/Title field, however, the cumulative count returns to 0 (zero) for more than 100
times (0=100, 1=101, 2=102, etc.).
In the Flash Power Control Screen and Modeling Lamp Power Control Screen, the
Multiple (cumulative) flash measurement is not available (only single measurement is
made).
Operation
1)
How to use Flash Triggering
1.
Touch the [Measuring Mode] Icon on the Measuring Screen.
The Measuring Mode Screen is displayed.
2.
Touch the [Radio Triggering Multi Flash Mode] Icon (
Measuring Mode Screen.
When it is selected, the display changes to the Measuring Screen.
[Measuring Screen]
[Measuring Mode] Icon
3.
Set the light receiving method.
Switch to the incident light, extended lumisphere (
(
), or reflected light.
[Measuring Mode Screen]
24
2. About Godox Radio System
) in
[Measuring Screen]
)/retracted lumisphere
●
Advertisement
Table of Contents
