Table of Contents
Advertisement
Warnings
SKIN INJECTION HAZARD
Spray from the gun, hose leaks, or ruptured components can inject fluid into your body and cause an
extremely serious injury, including the need for amputation. Splashing fluid in the eyes or on the skin
can also cause a serious injury.
•
Fluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate medical
attention.
•
Do not point the spray gun at anyone or at any part of the body.
•
Do not put hand or fingers over the spray tip.
•
Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
•
Do not "blow back" fluid; this is not an air spray system.
•
Always have the tip guard and the trigger guard on the spray gun when spraying.
•
Check the gun diffuser operation weekly. Refer to the gun manual.
•
Be sure the gun trigger safety operates before spraying.
•
Lock the gun trigger safety when you stop spraying.
•
Follow the Pressure Relief Procedure on page 6 whenever you: are instructed to relieve pressure;
stop spraying; clean, check, or service the equipment; and install or clean the spray tip.
•
Tighten all the fluid connections before operating the equipment.
•
Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
Do not repair high pressure couplings; replace the entire hose.
•
Fluid hoses must have spring guards on both ends, to help protect them from rupture caused by kinks
or bends near the couplings.
MOVING PARTS HAZARD
Moving parts, such as the air motor piston, can pinch or amputate your fingers.
•
Keep clear of all moving parts when starting or operating the pump.
•
Never operate the pump with the air motor plates removed.
•
Before checking or servicing the equipment, follow the Pressure Relief Procedure to prevent the
equipment from starting unexpectedly.
4
WARNING
306817N
Advertisement
Table of Contents
