Changing The Virtual Matrix - AMX CP-15 Instruction Manual

Changing the Virtual Matrix

Virtual matrices are defined in XNConnect and stored in the system's configuration file (see the
XNConnect Help file). Systems usually have a virtual matrix that contains all signals, so that any input
can be routed to any or all outputs. The same system may have other VMs that switch only audio signals
or only video signals.
Occasionally you may need to execute switches (or other operations) on a virtual matrix other than
the current virtual matrix. Changing the virtual matrix does not change the default virtual matrix. The
system will revert to switching on the default virtual matrix when the power is cycled. For information
on changing the default virtual matrix, see page 25.
The directions below give the steps for changing from routing signals on Virtual Matrix 0
"Audio/Video" to routing on Virtual Matrix 2 "Audio, Stereo."
To change the virtual matrix:
1. Press the Function Key.
The Function menu appears.
2. Locate Virtual Matrix by scrolling with the Control Dial.
3.
Press the Select Key.
The V. Matrix list appears.
4. Scroll to 2:Audio, Stereo.
5.
Press the Select Key to enter your selection.
The display returns to the top of the V. Matrix submenu.
VM 2 becomes the new virtual matrix used for all operations.
6. Press the Function Key to return to the Function menu.
The system is ready to make changes on Virtual Matrix 2 "Audio, Stereo."
The system will remain on Virtual Matrix 2 for all operations until the virtual matrix is changed or
the power is cycled.
CP-15 Instruction Manual
Changing the Virtual Matrix
Current VM
9