Applying Power - AMX CP-15 Instruction Manual

Applying Power

Power Requirements
Important: Always use a UL approved power source. Be sure to check the power source
documentation for information specific to that power source.
The instructions below are for using an AMX AutoPatch wall transformer.
To apply power to the CP-15 Remote using the wall transformer:
1.
Insert the power plug from the transformer into the power jack on the CP-15 Remote (FIG. 11).
2.
Place the CP-15 Remote in a rack or other permanent installation location before plugging the
transformer into the power source.
FIG. 11
Insert the plug into the power jack
CP-15 Instruction Manual
+24 volt DC with at least 600 mA per panel
Terminal Block Connector
Installing a CP-15 Remote Control Panel
Power Jack
29