Transport And Storage - Beko DRYPOINT M eco control DEC 1-30S Original Installation And Operation Manual

Installation and operating manual

1.4. Transport and storage

Despite our best efforts, transport damage cannot be excluded. Please therefore remove all packaging material immediately
after receipt and inspect the product for any possible transport damage. If you detect any damage, immediately notify the
carrier company and BEKO TECHNOLOGIES GmbH or one of its agents.
CAUTION Damage caused during transport or storage
Inappropriate transport or storage, or the use of unsuitable lifting equipment, might cause damage
to the device.
•
•
•
•
NOTE Recycling packaging material
•
6
The device may only be transported and stored by trained authorised and skilled personnel.
If you detect any damage, do not put the device into operation.
Always comply with the permissible storage and transport temperatures (refer to technical
data).
Never expose the device to continuous, direct sunlight or heat radiation.
The packaging material is recyclable. Dispose of the packaging material according to the
applicable statutory regulations.
The device must be stored in the original
packaging. Seal the packaging and store it in a
dry and frost-free room. Ensure that the ambient
conditions do not fall below or exceed the limits
specified on the type plate.
Always take suitable measures to protect the
device against the elements even in a packaged
condition.
While in storage, secure the device so that it
cannot topple over or fall, and protect it against
vibration.
DRYPOINT
EN
M eco control
®