General Safety Regulations; Personal Safety - Holmatro M 30 Series Manual

EN
NOTE
Emphasizes important information for optimal product use. This symbol is displayed in the
user manual with all regulations related to product use or maintenance.
Always adhere to these regulations and to the locally prevailing safety regulations, and proceed very
carefully.
Inform all people involved in the activities of the operation about these safety regulations.
2.2 Model plate and CE marking on the equipment
Refer to Fig. 1 to Fig. 9.
All pictograms attached to the equipment pertaining to safety and danger must be complied with and
remain clearly legible.
WARNING
Not following these instructions can result in serious personal injury, fatal accident, damage
to the system or consequential loss.
/i
Type of mark Pos.
Information 7
2.3

General safety regulations

• Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
• Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
• Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Rinse parts that have
come into contact with corrosive acid or liquid with a lot of water. Consult your Holmatro dealer for a
resistance list.
• Prevent dirt in and on the couplers.
• Protect equipment against sparks during welding or grinding activities.
• Avoid an unhealthy posture while working. It can result in physical complaints.
• Follow the inspection and maintenance instructions.
• Conversion of the piece of equipment or the system may only be performed by the Holmatro dealer.
In case of a conversion, retain the original manual and the conversion manual.
• Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.4

Personal safety

Personnel that uses or assists in the use of the equipment must wear all personal means of protection
as prescribed in the standard work procedure. Negligent use of personal means of protection can result
in serious injury. During use wear at least the personal means of protection as indicated in the manual
of the tool or the pump.
2.5 Safety regulations with respect to the equipment
• Always install the industrial control valve on a pump or an adapter plate.
• Make sure that all couplings are correctly installed.
• Make sure that there is enough light to read the gauges and to see the reaction of the connected
tools (if installed). Misinterpretation of the read-out of the gauges can cause dangerous situations.
24
Description
Manufacturer's information stating: name, address, CE marking,
model indication, serial number and date of construction,
maximum operating pressure, weight if heavier than 25 kg.
916.219.149_006
Part no.
920.299.576
M30* / M31* / M32* / VM43L