Table of Contents
Advertisement
Invacare® Gloss®
2.3 Inspection Checklist
Check points
Check that wheels and
forks work properly, are
free from defects and
are well fixed.
Check that the brake
system works properly
and is free from defects
Check that the folding
mechanism works
properly and is free
from defects
6
Possible issue
The wheel does not spin
easily.
The thread is torn or
damaged.
The wheel bolts are
loose.
The wheels are not
evenly adjusted in
height.
The screws on the rear
fork are loose.
The front fork is not
fixed to the frame.
The front fork is
damaged.
The rear fork is
damaged.
The front fork does
not spin evenly and
soundless.
The brake shoe is worn
out or deformed.
The brake shoe does
not return to its original
position after braking.
The brake wire does not
move easily in the wire
cover.
Poor braking effect.
The end parts of
the wire-covers are
damaged.
The brake handle or
the brake housing is
damaged.
When folding the
device, it does not stay
in a folded position.
The bolt in the folding
joint is loose.
The safety latch is
damaged or deformed.
Action
•
Replace the wheel and the
locking nut.
•
Replace the wheel.
•
Tighten the bolts.
•
Replace the locking nut.
•
Tighten the bolts.
•
Replace the locking nut.
•
Adjust the rear wheel fork.
•
Tighten the screws.
•
Tighten the screws.
•
Tighten the front fork with
60 Nm.
•
Replace the fork.
•
Tighten the front fork with
60 Nm.
•
Replace the fork.
•
Replace the fork.
•
Tighten the front fork with
60 Nm.
•
Replace the brake shoe.
•
Replace the brake shoe or
the wire and cover.
•
Replace the brake wire and
the cover.
•
Adjust the wire adjusting nuts
or the adjustment screws to
obtain full brake effect.
•
Replace the wire cover.
•
Replace the brake handle.
•
Replace the folding
mechanism parts including
the spring.
•
Re-assemble the bolt.
•
Use permanent locking glue.
•
Replace the safety latch.
Comments
Use permanent locking
glue if the locking nut is
missing.
Use permanent locking
glue if the locking nut is
missing.
The distance between
the brake flap and the
wheel must not exceed
2 mm.
1649877-A
OK
Advertisement
Table of Contents
