Advertisement
INDICATION LED STATUS (with the mains power supply connected)
POWER / CHARGE
Disconnected battery / not charging
Charged battery
Battery under charge
Indicator OFF
INSTALLATION PROCEDURE (For wall mounting only)
Mounting holes
Fig. 1
Cover
retaining
screws
LAMP FAULT
BATT. FAULT
indicator
TEST
button
1. Install the included mounting accessories to hook the device from the mounting holes (fig. 1).
2. Unfasten the 4 mounting screws to remove the front plastic cover (fig. 1).
3. Make sure that the battery's cables are connected to the respective poles. Black cable to (-) pole
and red cable to (+) pole.
4. Install the included cable gland or the rubber o-ring. Pass through the mains cable and stabilize it
by fastening the cable gland. Connect the wires to the terminal blocks L for live wire and Ν for
neutral.
5. Refit with care the front plastic cover, by fastening the 4 mounting screws (tightening torque
1N*m).
NOTE!! After finishing the installation you must power the luminaire at least for 24 hours for
battery charging to perform the nominal autonomy.
Battery replacement
It can be done only by a competent person and after the mains interruption.
1. Follow the step 2 of the installation procedure.
2. Disconnect the cables and remove the old battery.
3. Connect the new battery with the same type (step 3 of the installation procedure) and place it in
the position of the old one.
4. Follow the step 6 of the installation procedure and power the device.
Page 3 from 7
Indicator ON
Indicator Blinking
POWER
CHARGE
indicator
LAMP FAULT / BATT. FAULT
Normal operation mode
Low emergency duration (replace battery)
Lamp fault (Check lamps and replace if needed)
4
3
L
N
923037008_09_001
Advertisement
