Child-Proof Locks On Fully Extending Classic And Scala Drawers - VEDUM Wine shelf Instruction Manual

6. Installation of details

6.20 CHILD-PROOF LOCKS ON FULLY EXTENDING CLASSIC AND SCALA DRAWERS

50%
1. Remove the drawer by pulling it out 50% and then loosening it with an upwards jerk; install the lock as shown (1) at the
right-hand front edge of the frame runner in the cabinet. A clear CLICK can be heard when the lock is in the correct position.
2. Screw the child-proof lock in place under the drawer in the right-hand front edge (the same side as the safety stop
in the runner) according to the image, with a 4x20 mm countersunk screw.
Locking device
Activated (ON)
With a locking device, the child-proof lock can be activated or deactivated (see image). To use the child-proof lock, open the drawer a little and pull the lock.
6.21 CHILD-PROOF LOCK ART. NO. 39366 FOR BASE CABINET FOR OVEN ART. NO. 106360N
A B
Unscrew the system screw from the runner that is farthest out towards the front edge of the frame. Fit
1.
the locking plate (A) into the runner with system screw TFX 6.1x13 in hole 1 of the drawer runner.
Unscrew the rear system screw and attach the locking plate in the third hole of the drawer runner. In order to make it
2.
easier to access the screws: pull out the frame runner fully, which provides additional space for the screwdriver.
1
2
Drawer bottom
Deactivated
(OFF)
EACH CHILD-PROOF LOCK CON-
SISTS OF:
1 pcs locking plate (A)
1 pcs lock (B)
2 pcs screws 3.5x15 (C)
C
1
Mark where the lock (B) is to be located on the removed front, with C-C dimensions
3.
23 mm down from the top edge of the front and 50 and 67 mm respectively in from
2
the edge of the front. Pre-drill two holes (Ø2x3 mm), and screw the lock into place
with the Ø3.5x15 mm (C) screws.
CLICK
23 mm
50 mm
17 mm
3
59