Table of Contents
Advertisement
3. Installing wall cabinets
3.4 FAN SHELF WITH DOOR
3.5 INSTALLATION AND ADAPTATION OF FLEXIBLE FAN MODULE ART. NO. 38730-38731
1. Cut down the sides so that they are adapted to the fan in
question, so that the measurement between the stove/hob and
the underside of the fan is 500 mm after installing the fan. Also
cut down the front in relation to the fan in question. Bear in
mind that the front must be located exactly at the bottom edge
of the cabinet above, and that there should be a free space
of approximately two millimetres between the fan and the front.
2. Install the sides so that the cut surface is facing up towards
the cabinet above and the surface with the edge strip is facing
1
30
If necessary, cut the underside of the fan shelf so that it matches the
height of the fan. Bear in mind that the distance between the hob and
the fan must be at least 500 mm. Different fans will require different
distances from the hob. See the fan supplier's instructions.
From the supplied fittings bag, the connection fittings are assembled,
the white screw head and stud bolt, for fitting to the upper edge. In the
fan shelf, there is a pierced hole where the connection fitting should
be fitted. First drill a 6 mm hole to the adjoining cabinet and fit the
connection fitting with the white screw head from the fan shelf side
and the wingnut in the adjoining cabinet. Then drill a 5 mm hole in the
bottom edge from the adjoining cabinet and press on the eyebolt with
the bolt from the adjoining cabinet as a pin.
Bear in mind that the wing nut and eyebolt will be visible if any adjoining
cabinet is open!
If you choose to screw the fan shelf into place with a connection
screw instead, carrying out a check with a local chimney-sweep is
recommended to ensure that this is an approved solution.
down. Installed with four connection screws/side with art. no.
39611 TFX 4.0x28 as per the image. The connection screw is
not included in the accessory bag, rather it is included with the
kitchen delivery.
3. Install the panel holders on the sides so that they are flush
against the bottom of the cabinet installed above, and have
both edge wings on the outside of the frame. Screw the panel
holders into place with four screws each, TKX 4.0x15, as shown.
6
2
7
5
3
4
Advertisement
Table of Contents
