Installing The Protruded Plinth - VEDUM Wine shelf Instruction Manual

1. Installing base and tall cabinets

1.11 INSTALLING THE PROTRUDED PLINTH

1. Install the base cabinets in accordance with the regular installation guide
with supporting legs in the standard position (check whether the
protruded plinth is to be installed on the sides, in which case the
supporting legs must be moved in at least 39 mm from the side to
provide room for the combination strip art. no. 3857).
2. Knock off the studs on the supporting leg attachment art. no. 39202, use
a hammer.
3. Take care to install the supporting leg attachment at the front edge of
the combination strip art. no. 3857 with three screws TKX 4.0x12 from
accessory bag art. no. 39369. You are recommended to have five
supporting legs per full length plinth 2400x130x16 mm.
4. Place the supporting legs art. no. 39203 with H=100 mm in the
supporting leg attachment. When the supporting leg has been adjusted
to its outermost position, the maximum height is 152 mm.
5. Place the combination strip under the frame so that it protrudes 22 mm.
Screw up the supporting legs so that the combination strip is pressed up
against the bottom of the cabinet frame. Measure again and adjust
if necessary.
11
4
3
11
2
4
3
16
11
22 mm
Integrated dishwasher
2
11
22 mm
NOTE! Shows the back of the plinth
6. Screw the combination strip into place from inside the cabinet frame,
through the bottom and down into the combination strip, with connection
screw art. no. 39611 TFX 4.0x28 mm, which is included in the rest of the
kitchen delivery, not specifically with the protruded plinth delivery.
Recommendation max. C-C 600 mm between the screws!
When installing with screws from inside the frame, the screw heads can be
covered with white cover plugs, 20 mm, with art. no. 39226, which must be
ordered additionally.
7. Measure the plinth and cut to the correct length. If the plinth has to be
cut on the underside, seal the rough surface with wood glue, RubberFix
or silicone (not included in the delivery from Vedum) and allow it to dry
before installation. It is also possible to use a transparent plinth strip with
art. no. 38004.
8. Place the plinth in front of the supporting legs and mark the centre of the
supporting leg on the plinth, where the mounting attachment is
subsequently screwed in place.
1
9. Assemble the plinth clip and the mounting attachment. Screw the
mounting attachment onto the plinth with screw TKX 4.0x12 mm so that
6
the screws are approximately 75 mm from the bottom edge of the plinth.
10. In front of the dishwasher, the protruded plinth with a height of 130 mm is
used if you do not need to have a recess in the plinth due to the
dishwasher door going so far down towards the floor in its lowered
5
6
5
12
1