Fully Extending Classic And Scala Drawers - VEDUM Wine shelf Instruction Manual

6. Installation of details

6.12 FULLY EXTENDING CLASSIC AND SCALA DRAWERS

REMOVING AND REPLACING THE CLASSIC/SCALA DRAWER
50%
50%
To remove the drawer, pull the drawer out to 50% and then
remove it by lifting the front edge of the drawer straight up.
ADJUST THE FRONT
SIDEWAYS ADJUSTMENT CLASSIC/SCALA
Behind the front, under the drawer, there is
a hook on each side. To adjust the drawer
front sideways, move the hooks back and
simultaneously pull the drawer front side-
ways. Adjustment range: +/- 1.5 mm.
+
REMOVING AND REPLACING THE
CLASSIC/SCALA DRAWER FRONT
Behind the front, under the drawer, there is a
hook on each side. To loosen the front, move
the hooks backwards and pull the drawer
front upwards and outwards at the same
time. To reinstall the front, place the lower
part of the front fittings against the groove
at the front edge of the drawer side, then
press the front downwards and inwards.
50
HEIGHT ADJUSTMENT CLASSIC/SCALA
Screw A is a locking screw (tall Scala
drawers have 2 locking screws) and
screw B is an adjusting screw. Loosen the
-
locking screws and then adjust the drawer
front vertically using the adjusting screws
on either side. Then lock the locking
screws again. Adjusting range: +/- 2 mm.
To replace the drawer – place
the drawer on the fully extended
runners and slide the drawer into
the cabinet.
GRADIENT ADJUSTMENT SCALA
At the back on the inside of the drawer,
there is one screw on either side. Adjust
the gradient of the front with the
adjusting screw on either side.
GRADIENT ADJUSTMENT CLASSIC
Adjust the gradient of the front by screwing
on the drawer's railings on either side.
CLICK!
When you hear a *click*, the
drawer has settled on the
runners again.
50% 50%