Preparation Of The Workplace; Preparation Of The Coating Material; Start-Up - WAGNER W 400 Translation Of The Original Operating Instructions

GB

9. Preparation of the workplace

Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area. No liability is assumed for damage
due to overspray.
Silicate paint corrodes glass and ceramic surfaces upon contact! All
such surfaces must therefore be completely covered.
Pay attention to the quality of the adhesive tape used.
i
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.

10. Preparation of the Coating Material

Spray material that is at least at room temperature (e.g. diluted with warm
i
water) provides a better spray result.
Attention! Do not heat spray material above 40°C.
Interior wall paints can be sprayed undiluted or slightly diluted with the spray attachment
provided. Detailed information is available in the technical data sheet of the manufacturer
( Internet Download).
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution (an agitator is recommended for stirring).
Sprayed material
Interior wall paint (dispersions and latex paint)
2. If the feed rate is too low even at maximum flow setting, dilute in steps of 5 - 10 % until
the feed rate meets your requirements.

11. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed without
almost any residue.
22
Thinning recommendation
W 400
dilute by 0-10 %