olympia electronics GR-8/leds Quick Start Manual

LED Characteristics
GR-8/leds
MANUFACTURER Olympia Electronics S.A.
MODEL NUMBER 2201159
VOLTAGE RANGE 2.9-3.6V DC
NOMINAL POWER 780mW
CONNECTIONS Non reversible connection between main pcb and led module
TEMPERATURE (tc) 45 C max. across the board °
Pictogram Installation
The luminaire can be used as a safety sign. Place the apropriate pictogram to the
luminaire. In the package are icluded 3 pictograms:(807008002 Set of
Pictograms: Arrow Right, Arrow Left, Arrow Down).
Various directions and symbols can be provided upon request.
Note!! The installer should fill in, on the specification label, the letter G if the
luminaire is used as a safety sign.
X 1 A 9 0
G
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
1: Maintained operation (*)
A: Including test device
G: Internally illuminated
90: 90 minutes duration
180: 180 minutes duration
(*) Maintained operation: The luminaire lights its illumination source, when it
is powered by the mains power supply or not.
Non Maintained operation: The luminaire lights its illumination source, only in
power supply's failure.
Battery Replacement
It can be done only by a competent person and after the mains
interruption.
1. Dismantle the device (step 1 of the installation instructions).
2. Disconnect the connector and remove the old battery.
3. Connect the new battery with the same type (step 6 of the
installation instructions) and place it in the position of the old one.
4. Follow step 7 of the installation procedure and power on the
device.
4
Technical Characteristics
GR-9/leds
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY (Ni-Cd)
INDICATIONS - CONTROLS
CHARGE TIME
MINIMUM DURATION
LIGHT SOURCE
ILLUMINATION (MAINS/EMERGENCY )
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
VIEWING DISTANCE (as safety sign)
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIAL
EXTERNAL DIMENSION (L x W x H)
WEIGHT
GUARANTEE
Warranty
Olympia Electronics guarantees the quality, condition and operation of the
goods. The period of warranty is specified in the official catalogue of Olympia
Electronics and also in the technical leaflet, which accompanies each product.
This warranty ceases to exist, if the buyer does not follow the technical
instructions included in official documents given by Olympia Electronics, or if the
buyer modifies the goods provided or has any repairs or re-setting done by a third
party, unless Olympia Electronics has fully agreed to them in writing. Products
that have been damaged can be returned to the premises of our company for
repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods
and to or not charge the buyer depending on the reason of defection. Olympia
Electronics reserves the right to charge or not the buyer the transportation cost.
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
5
923378005_09_010
GR-8/leds GR-9/leds
220-240V AC / 50-60Hz
2.7 W / 3 VA 3 W / 3.5 VA
3.6V/0.6Ah 3.6V/1Ah
Charge LEDs, TEST Button
24 hours
1.5 hour 3 hours
12 white LEDs
40lm / 100lm 38lm / 100lm
IP42
EN 60598-1, EN 60598-2-22, ΕΝ 55015,
ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
15m
o
5 to 40 C
Up to 95%
ABS/PC, PC
240 x 90 x 44 mm
345gr. 350gr.
3 years (1 year for the battery)
www.olympia-electronics.com
info@olympia-electronics.gr
923378005_09_010
European
manufacturers
GR-8/leds, GR-9/leds
NON-MAINTAINED / MAINTAINED
EMERGENCY LUMINAIRES
M NM TB
Maintained Non
IP42 15m
Test button
maintained
Thank you for your trust in our products
Olympia Electronics - European manufacturer
Light output
Ni-Cd 100lm