Notes For Replacing The Evf; Procedure Of The Adjustment Values Writing When Replacing Vc Board - Sony PXW-X160 Service Manual

2-4.

Notes for Replacing the EVF

Adjustment values of each EVF display device are stored on the VC board.
Therefore, when the EVF display device or the VC board has been replaced, write adjustment values.
10/11_193_26_0
The label which is put on repairing EVF display device
Procedure of the adjustment values writing when the EVF display device is replaced:
1. Check and write down the adjustment values printed on the repairing EVF display device label.
2. After the EVF display device has been replaced, execute "EVF Data Input" on the ADJUST tab by using the
Adjust Manual in the Adjust Station to write the adjustment values.
Procedure of the adjustment values writing when replacing VC board (in case adjustment
values can be read):
1. Start the Adjust Manual in the Adjust Station before replacing the VC board, and execute [DATA READ AND
SAVE] in the "ADJUSTMENT DATA BACKUP" on the DATA tab to extract adjustment values.
2. Start the Adjust Manual in the Adjust Station after the VC board has been replaced, and execute [DATA LOAD
AND WRITE] in the "ADJUSTMENT DATA BACKUP" on the DATA tab to write the extracted adjustment
values.
Procedure of the adjustment values writing when replacing VC board (in case adjustment
values cannot be read):
1. Read the QR code printed in EVF display device using with "QR_Code_Reader_Ver1.0_x64".
2. Make sure the adjustment value from the read value as shown below, and memorize it.
Example: In case the read value is "1958817021A"
Brightness value
3. Start the Adjust Manual in the Adjust Station after the VC board has been replaced, and execute "EVF Data
Input" on the ADJUST tab to write the adjustment values.
PXW-X160/PXW-X180
White balance value
Brightness value
White balance value
195 = Brightness value
17 = White balance value
2-4