GMW TG uni 1 Operating Manual page 30

Operating manual for the TG uni 1, TG euro 1 and TG euro 1 med appliance tester
Conducting tests in accordance with DIN VDE 0701-0702, Example 1 – Devices with a protective conductor (PC I)
You confirm the entries by pressing the [save] button – a „Data were
stored" message is displayed briefly and the display changes to Fig 39.
With the entry of an already used ID number, the data is „attached" as a
new test to this ID number.
After saving, the display changes to the screen for entering the ID number –
the appliance tester is now ready for another test (Fig. 40).
The test results can be saved on a PC with the supplied PC program or
printed from there in the form of a test log. To do this, establish the USB
connection between the appliance tester and the PC* (USB cable supplied)
or directly copy the saved data from the memory card to the PC using a
card reader.
Procedure on the PC – see the operating instructions for the PC software.
* Switch the appliance tester off and on, leave the switch-on message as it is (Fig. 41).
Connect the USB cable. The appliance tester is automatically detected by Windows® as
removable media. The internal memory is assigned to the first free drive letter and the
memory card is assigned to the second free drive letter.
Fig. 40
General information
Every test stage during which the test object is supplied with mains voltage
is time limited for reasons of safety.
The maximum duration of this test stage is approx. 5 minutes. This means
that the appliance tester will not remain in a state where the test object is
supplied with mains voltage for longer than approx. 5 minutes.
After this time, the mains voltage is switched off and an appropriate
message is shown in the display.
At this point you can continue the test with the [next] button or cancel it with
the [cancel] button.
DIN VDE 0751/EN 62353 at TG euro 1 med only
Fig. 41
30
Fig. 42