Table of Contents
Advertisement
USER ("A") MENU
ENTERING THE USER MENU
1. Enter the Setup ("F") menu by following the directions above.
2. Use the right or left directional keys shown in Figure 3-3 to move right or left in the Setup ("F") menu until the indicator shows " A 1".
NAVIGATING IN THE USER MENU
1. Use the directional keys shown in the Figure to move around in the User Menu Chart.
2. To move to the selection level, press ZERO/OFF (down) key once. The current saved selection is shown.
3. To move to a new "F" heading, use TARE (left) or ON/PRINT (right) key to move right or left in the User Menu Chart.
4. If you want to go back whithout saving press lb/kg.
5. If a digit flashing, use lb/kg and ZERO/OFF for choosing value.
6. To save a new selection, press the NET/GROSS (Set) key .To exit without saving, press the PRINT (up) key to return to the current "F"
heading.
7. You can cancel calibration anytime with switching back to normal mode. An alternative is to disconnect the power.
A1
Baud Rate
1200
2400 4800 9600
A6
Serial Port Mode
0
1
ID Number Entry (A8)
1. While in the User Menu mode, scroll to "A 8", then scroll down once using the ZERO key to enter the ID Number menu.
2. The display will momentarily show "ID NO", followed by a value with one flashing digit.
3. Use the four directional keys to adjust the displayed value to the actual ID Number value. Increase/decrease the flashing digit by pressing
the lb/kg or ZERO/OFF key.
4. After setting the exact value, press the NET/GROSS key to save the ID Number value. The display will show "SET" momentarily, then
revert back up to A8.
LF (Line Feeds) Number Entry (A9)
1. Go to "A9".
2. The display will momentarily show "LF", followed by the current line feeds value.
3. Use the four directional keys to adjust the displayed value
4. After setting the exact value, press the NET/GROSS key to save.
A2
A3
Data Bits, Parity
Transmission Mode
8n
7O
7E
7n
C
A7
A8
ID No. Enable
ID No. Entry
0
1
A4
Display Check
Press ZERO
d
key to begin
A9
No. of Line Feeds
Press ZERO
Press ZERO
key to begin
key to begin
OFF
1
2
A5
Enable lb/kg Key
0
1
A10
Auto Power Off
3
5
8
10
15
20
30
Manual page 9
Advertisement
Table of Contents
