A.channel Setting - Ameriphone AM6000 User Manual

Instrucciones de seguridad
IN CASE OF DIFFICULTY
importantespara el usuario
Channel Setting
The Alertmaster System uses special
radio signals to communicate between
the console unit and all its accessories.
For the accessories (Door Announcer,
Baby Sound Monitor, Audio Alarm
Transmitter and Motion Sensor) to
activate the base unit, they all have to
be on the same "channel." A "DIP
Switch" is used for channel selection.
Your system and all the accessories
have been preset in the factory to a
standard channel setting. Under
normal operating conditions, there is
no adjustment necessary.
If your system encounters interference
and repeatedly activates itself for no
obvious reason, it may be
triggered by a system nearby in your
neighborhood.
If the interference from another
Alertmaster Notification System or
other wireless source is present,
change channel switch settings on all
components.
1. Unplug AC power and locate
DIP Switch (a 4-position switch)
on the underside of the Alertmaster
AM-6000.
2. Open the battery compartment
of the doorbell.
3. Change the switch position of
each switch on both units using
a ball point pen. All settings
need to be identical for the
system to work. See Figure 5.
4. Change the switch settings on
each of your other accessories
(Remote Receiver, Audio Alarm
Transmitter, Baby Sound
Monitor, etc.) to match the new
channel setting.
5. Replace all covers and return
accessories to their proper
places.
Press LAMP CONTROL /
RESET button once to reset the unit.
Use a pen or
pencil to set
DIP Switches
to match
exactly
Doorbell Transmitter
Figure 5 - Channel setting
Alertmaster base unit
E
N
G
L
I
S
H
17