In Case Of Difficulty - Ameriphone AM6000 User Manual

Instrucciones de seguridad

IN CASE OF DIFFICULTY

importantespara el usuario
If any problem should occur during operation of your Alertmaster Notification
System, review the "Symptom and Remedy" list below. Make sure no part of the
Alertmaster system is on or near metal surfaces or electronic equipment. Should the
difficulty persist, contact AMERIPHONE or your authorized dealer for assistance.
Lamp control button doesn't work
Phone rings, lamp doesn't flash
Alarm clock doesn't work
Bed shaker doesn't vibrate
Room noise doesn't activate
Lamp flashes constantly
Doorbell doesn't work
16
SYMPTOM
CAUSE AND REMEDY
Lamp is not turned on prior to plugging it
into Alertmaster. Turn the lamp's switch on.
Replace bulb if necessary.
Check all phone line connections. Make
sure you can turn the lamp on or off with
the lamp control button.
Alarm clock is not turned on. Slide the
switch to the ON position.
Bed shaker is unplugged. Plug it in. Coil
the wire once around the plastic loop to
prevent accidental unplugging.
Switch is OFF . Slide it to the ON position.
Sound must be continuous for twelve sec-
onds for room noise to activate.
There is constant noise in the room, and
the sound function is on. Slide the switch to
OFF .
Dead battery. Depress doorbell button,
red light on housing should light up. If not,
battery needs to be replaced. If the battery
is fully charged, the dipswitches may be
incorrectly set. See section on
Setting
on page 13.
Channel