Table of Contents
Advertisement
PREFERENCE SETTING
3) Volume Display Format
4) Stairwell—Headroom Height
5) Rake-Wall Descending
6) Arched Wall Outside
7) Jack Rafters Descending
8) Irregular Jack Rafters
9) Exponent Off or On
10) Meter Linear Display
11) Decimal Degree Display
12) Fractional Mode
OPTIONS
– Square Feet (area answers displayed in Square Feet
regardless of unit entry - e.g., Inches x Inches)
– Square Yards (area answers always displayed in Square
Yards - e.g., Feet x Feet = Square Yards)
– Square Meters (area answers always displayed in Square
Meters - e.g., Feet x Feet = Square Meters)
– *Standard (if units entered are the same - e.g., Feet x
Feet x Feet - the answer will remain in this format (cu. ft),
but if units entered are different - e.g., Feet x Feet x Inches
- volume answer will always be displayed in Cubic Yards)
– Cubic Yards (answers always displayed in Cubic Yards,
regardless of unit entry - e.g., Feet x Feet x Feet = Cubic
Yards)
– Cubic Feet (vol. answers always displayed in Cubic Feet,
regardless of unit entry - e.g., Inches x Inches x Inches =
Cubic Feet)
– Cubic Meters (answers always displayed in Cubic Meters,
regardless of unit entry - e.g., Feet x Feet x Feet)
– *6 Feet 8 Inch (default)
– Use + or – key to increase or decrease above value by
1 Inch
– *Descending (Rake-Wall studs are or Ascending displayed
from largest to smallest size)
– Ascending (Rake-Wall studs are displayed from smallest to
largest size)
– *Outside (Arched walls are calculate or Inside for outside
of the arc)
– Inside (Arched walls are calculated for inside of the arc)
– *Descending (Jack rafters are or Ascending displayed from
largest to smallest size)
– Ascending (Jack rafters are displayed from smallest to
largest size)
– *OC-OC (On-center spacing maintained O-C or Mate on
both regular and irregular sides)
– JAC-JAC (regular/irregular Jack rafters "mate" at the hip
valley, e.g., On-center spacing not maintained on both
sides)
– *Off (Exponential Mode is Off; turns on Auto-ranging; e.g.,
if display can't show seven digits, will display in next
largest unit).
– On (Exponential Mode is On)
– *0.000 (linear Meter answers are always displayed to third
decimal place)
– FLOAt (linear Meter answers are displayed to the
maximum number of decimal places -
e.g., 1.234 M + 2.56 M = 3.794 M)
– *0.00° Display
– FLOAt
– *Standard (fractions are displayed to the nearest fraction)
– Constant (fractions are displayed in the set fractional
resolution)
Page 48
Advertisement
Table of Contents
