American Megatrends Baby Screamer LC User Manual page 57

H a r d D i s k U t i l i t y E r r o r M e s s a g e s , H a r d D i s k U t i l i t y E r r o r M e s s a g e s ,
O p e r a t i o n E r r o r s O p e r a t i o n E r r o r s
Baby Screamer LC Motherboard User's Guide
Continued
Message
Address Mark Not The address mark (initial address) on the hard disk
Found could not be found.
Attachment Failed to No response has been received from the hard disk
Respond drive.
Bad ECC on Disk When the hard disk drive utility writes to the disk, it
Read also calculates an ECC (Error Correction Code)
value for the data being written. This ECC value is
written to the drive and then read back. The value
read back is different from the one calculated.
Bad Sector Flag An operation was performed on a sector that has
Detected been flagged as bad.
Controller Has Failed A diagnostic command was issued to the controller
failed.
Drive Not Ready An operation on the hard disk drive has timed out.
The hard disk drive utility has waited beyond a
preset specified time limit.
Drive Parameter A reset command was sent to the controller
Activity Failed followed by drive parameters. Using these
parameters, the controller did not get a response
from the hard disk. Make sure the drive type is
correct.
ECC Corrected Data The ECC value (explained above) read from the disk
Error is not the same value which was written to the disk.
The data is not correct. An attempt was made to
correct the data, but the ECC value is not corrected.
Requested Sector The requested sector could not be found.
Not Found
Reset Failed The reset command did not properly reset the hard
disk.
Seek Operation A seek command failed. A seek operation is the act
Failed of finding a particular sector on the hard disk.
Undefined Error - An unidentifiable error condition occurred.
Command Aborted
Write Fault on A write fault occurred during the write operation on
Selected Drive the hard disk drive.
Explanation
5 3 5 3