Chapter 2 Installation; Unpacking - American Megatrends Baby Screamer LC User Manual

Chapter 2 Chapter 2
Installation Installation
U n p a c k i n g U n p a c k i n g
Baby Screamer LC Motherboard User's Guide
S t e p S t e p
1. Inspect the cardboard carton for obvious damage. If damaged, call
Technical Support at 404-246-8600.
Leave the Baby Screamer LC motherboard in its original packing.
2. Perform all unpacking and installation procedures on a ground
connected anti-static mat. The operator should wear an
anti-static wristband, grounded at the same point as the
anti-static mat. Or use a sheet of conductive aluminum foil
grounded through a 1 megohm resistor instead of the anti-static
mat. Similarly, a strip of conductive aluminum foil wrapped around
the wrist and grounded through a 1 megohm resistor serves the
same purpose as the wrist-band.
3. Inside the carton, the motherboard is packed in an anti-static bag,
and sandwiched between sheets of sponge. Remove the sponge
and remove the anti-static bag. Place the motherboard on a
grounded anti-static surface component-side up. Save the original
packing material in case of reshipment.
4. Inspect the motherboard for damage. Press down on all ICs
mounted in sockets to verify proper seating. Do not apply power to
the motherboard if it has been damaged.
5. If the motherboard is undamaged, it is ready to be installed.
A c t i o n A c t i o n
5 5