Husqvarna 525LK Operator's Manual page 11

4. Pull the attachment straight out of the coupling.
C
To assemble the cutting attachment
guard and trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head. Refer to
2. Put the cutting attachment guard onto the fitting on
the shaft.
3. Attach with the bolt (L).
A
4. Install the drive disc (B) on the output shaft.
5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
6. Put the locking pin (C) in the hole to lock the shaft.
7. Turn the trimmer head /plastic blades (H) in the
opposite direction from which the trimmer head/
plastic blades rotates.
H
1027 - 002 -
Accessories on page 21 .
B
C
A
H
To disassemble the cutting attachment
guard and trimmer head
1. Turn the trimmer head /plastic blades (H) in the
direction from which the trimmer head/plastic blades
rotates.
H
2. Pull the locking pin (C) out from the hole to unlock
the shaft.
3. Remove the drive disc (B) on the output shaft.
4. Loosen the bolt(L) from the cutting attachment
guard-fitting on the shaft.
A
5. Remove the cutting attachment guard (A).
H
B
C
A
11