Step 4 Connect Power and Network Cables
Check the power supplies in the back of the chassis. Both must be in the "On" position.
Connect the power cords and RJ-45 cables to the ports shown below:
NIC1
NIC2
Plug your network cable into the above RJ-45 Jack
Step 5 Install Hard Drives
Step
1
2
3
Symbol
Description
I
On
O
Off
Plug the power cords into both power supplies.
Power Supply 1
Diagram
Power Supply 2
Description
Unlock the lid.
Lift the lid up.
Physically remove the lid and select an
available eZswap™ bay.
Hardware Installation
Cont'd
7