American Megatrends StorTrends 1108-J User Manual page 11

Step 2 Install CPU and Memory,
Step
5
6
7
8
Continued
Diagram Description
Remove the rear cover and locate the
motherboard.
Locate the Socket 370 and insert the CPU.
Mount the cooling fan and heatsink on top of
it. Plug the CPU cooling fan into connector
JP6. It is a 3-pin berg that connects the fan on
the CPU heat sink to the motherboard power.
JP6 is located in-between the CPU and
memory slot.
Connector JP6 is keyed in such a way that the
CPU connector can only be attached one way.
The SDRAM DIMM socket on the
motherboard can be populated with one of the
following:
•
8 MB 168-pin 3.3V SDRAM
•
16 MB 168-pin 3.3V SDRAM
•
32 MB 168-pin 3.3V SDRAM
•
64 MB 168-pin 3.3V SDRAM
• 128 MB 168-pin 3.3V SDRAM
•
256 MB 168-pin 3.3V SDRAM
In order for you to insert the memory module,
you must remove the I/O shield. Unscrew the
four screws that secure the rear I/O shield. Lift
the shield along with the network interface
connectors and cables out of the way. Insert the
memory and replace the rear I/O shield.
Place the rear cover back on the chassis and
secure it with the four screws.
Now you are ready to install the StorTrends
1108 into your enclosure.
Hardware Installation 5