Ordering Parts - American Dynamics SpeedDome Ultra III Installation And Service Manual

Updating/Reprogramming
Dome Software
To update or reprogram dome software:
1. Remove flash memory chip.
Insert chip extractor tool into square access
hole and squeeze to extract flash memory chip
(Figure 36).
CAUTION: Electrostatic-sensitive device. Use a
ground strap when handling chip.
2. Reprogram chip or replace it with new chip.
3. Reinsert chip.
Align dot on chip with indent on socket, then
push down on chip to reinsert it.
Figure 36. Removing the flash memory chip
28 INSTALLATION AND SERVICE GUIDE

Ordering Parts

This section helps you to identify parts that make
up the base and housing and eyeball assembly.
See Figure 37 for parts breakdown.
Order parts through your parts distribution network.
SpeedDome Ultra III Camera Dome
8000-2573-01, REV. B