Self-Tapping Screw Installation; End Cover Replacement - American Dynamics ADRL3TRK Series Service Manual

Self-Tapping Screw Installation

Two self-tapping screws, one at each at each end
of the rail, prevent the PVC holder from coming out
of the rail.
Using a drill with a Phillips bit, thread each screw
into the rail as shown below. Ensure the screw
does not touch the copper or connector at the start
and end of the rail.
SENSORRAIL IIIE
SERVICE GUIDE

End Cover Replacement

If RF video dropouts occur, use the black plastic
end cover ADRL3ECB. Affix the plastic cover using
the same screws that held the metal version.
CAUTION: The black cover is only used
with the new rail extension containing
the top hat. DO NOT use this cover
without the rail extension. See "Light
Reduction Kit" on page 25.
29 of 34
8200-0593-03, REV. A