Trolley Check And Maintenance - American Dynamics ADRL3TRK Series Service Manual

Trolley Check and Maintenance

1. Using a soft cloth soaked with alcohol, clean the
following trolley parts:
• Tracking wheels (4)
• Stabilization wheels (2)
• Pressure roller (1)
• Sliding contacts (4).
2. Using a soft cloth dry clean (without alcohol) the
following trolley parts:
• Optical sensors
• Dome lens.
3. Check wear on the following trolley parts:
• Wheels (tracking and stabilization)
• Sliding contacts
• Pressure roller belt wear
4. Perform an overall check of trolley parts such as
collectors and pantographs.
SENSORRAIL IIIE
SERVICE GUIDE
Guiding and Stabilizing Wheels
Tracking and stabilizing wheels absorb vibrations
and force coming from the trolley movement and rail
junctions.
Estimated lifetime for these wheels is 10000km;
therefore, no replacement should be expected.
However, for safety reasons, check for lateral
excess movement of the bearings.
Sliding Collectors
When copper collectors are worn, the plastic
support can slide against the PVC holder. This will
generate noise and dust and can potentially
deteriorate the PVC holder.
Check the height between the contact surface and
the bottom of the plastic support. New contacts are
20mm thick. As shown below, if the collector is worn
more than 3mm, replace it. Estimated lifetime for
contacts is 8000km.
17mm
13 of 34
20mm
8200-0593-03, REV. A