Tools - Husqvarna DM 230 Workshop Manual

The tools listed below are available from Husqvarna.
● = Service operation
510 22 11-01
Special socket
● Tool Necessary for adjusting the
intermediate shaft's slip clutch.
1/2 inch socket wrench attach-
ment.
Workshop wrench, Hex
● Universal use.
502 50 19-01 3 mm
502 50 18-01 4 mm
502 50 64-01 5 mm
504 90 00-01 6 mm
502 71 27-02
Workshop wrench, Torx T27
Universal use.
●
504 90 00-06
Workshop set,
mm-dimensions
● Universal use.
Hex: 3, 4, 5 and 6 mm
Socket: 8 mm
504 90 90-02
Universal puller
Bearing dismantling.
●

TOOLS

The special tools below are needed for service work to DM 230
but are not sold by Husqvarna.
Lock ring pliers
Make: Milbar/Imperial IR-15R.
Pliers for small lock rings
without eyes.
● Dismantling and fitting of the
spindle shaft's lock ring.
Counter stay device
There are a number of manufactu-
rers, e.g.: Kukko (Germany),
Snap-On (USA).
Dismantling of ball bearings
●
and needle bearings in gear
housing and gear box cover.
● Removal of oil seals (radial
seals).
Multimeter
Make: Amprobe 37XR-A.
One of few universal instru-
ments that can also measure
inductance (H, Henry).
● Check of electric motor's
functions.
12
19