Technical Data; Before Starting The Equipment; Sound And Vibration - Toolson PRO-ST 85 K Operating Instructions Manual

Anleitung PRO_ST_85_K_SPK7:_

4. Technical data

Nominal voltage: 230 V ~ 50 Hz
Power consumption:
Cutting rate: 800-3000 strokes/min
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Mitre cuts: up to 45° (left and right)
Double isolation
Weight
Laser class
Laser wave length
Laser output

Sound and vibration

Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Cutting wood
Vibration emission value a = 5.12 m/s 2
h
K uncertainty = 1.5 m/s 2
Cutting sheet metal
Vibration emission value a = 15.20 m/s 2
h
K uncertainty = 1.5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
30.03.2009 13:48 Uhr

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
750 W
are identical to the mains data.
Always pull the power plug before making
23 mm
adjustments to the equipment.
85 mm
5.1 Safety guard (Fig. 2/Item 17).
10 mm
The safety guard (17) prevents accidental
6 mm
contact with the saw blade (15) whilst still
allowing the user to view the sawing area.
The safety guard (17) must always be fitted and
II /
in position before starting any sawing work.
2,6 Kg
The safety guard (17) can be pulled up as shown
2 in Figure 2.
650 nm
5.2 Changing the saw blade
≤ 1 mW
(Figures 3-4 / Item 15)
Important!
You can fit or replace saw blades without using
any other tools.
Pull the mains plug before you fit or replace a
saw blade.
Set the switch for pendulum action (10) settings
to position 3.
92 dB(A)
The teeth of the saw blade are very sharp.
Pull up the safety guard (17) (see point 5.1).
3 dB
Push the holder for the saw blade (16) towards
103 dB(A)
the tool and insert the saw blade (15) into the
3 dB
saw blade holder (16) as far as possible (Figure
3). The teeth on the saw blade must be pointing
to the front.
Allow the holder for the saw blade (16) to slide
back. The saw blade (15) must sit in the guide
roller (12) (Figure 4).
Check that the saw blade (15) is secure in the
holder.
Follow the instructions above in reverse order to
remove the saw blade.
5.3 Fitting the parallel stop (Figure 5 / Item 13)
The parallel stop (13) enables you to saw parallel
cuts.
Undo the two locking screws (14) on the
soleplate (14).
No slide the parallel stop (13) into the guide on
the soleplate (9). You can fit the parallel stop
(13) on either the left or right of the tool.
The guide strip must always face downwards. Fix
the required distance using the measurement
scale on the parallel stop (13) and tighten the
locking screws (14) again.
Seite 11
GB
11