Removing The Transit Bolts - Siemens iQ500 User Manual And Installation Instructions

WARNING
Risk of electric shock!
The appliance contains live parts.
Touching live parts is dangerous.
Do not operate the appliance
▶
without a cover cap.
WARNING
Risk of injury!
When using the appliance on a base,
the appliance may tip over.
Always secure the feet of the appli-
▶
ance to a base using the manufac-
turer's "fixing brackets"
→ Page 30 before using the ap-
pliance for the first time.
ATTENTION!
¡ If the appliance is installed in
areas exposed to frost or out-
doors, frozen residual water may
damage the appliance and frozen
hoses may crack or split.
Do not install or operate this ap-
▶
pliance anywhere that is liable to
experience frost and/or out-
doors.
¡ The appliance underwent a func-
tion test before leaving the factory
and may, therefore, contain resid-
ual water. This residual water may
leak out if the appliance is tilted at
an angle greater than 40°.
Tilt the appliance carefully.
▶
Installation location Requirements
On a base Secure the appliance
with "fixing brackets"
→ Page 30.
Installation and connection en
Installation location Requirements
On a wooden joist
floor
In a kitchen unit
On a wall

Removing the transit bolts

The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Notes
¡ Please read the information in the
"Safety" → Page 4 and "Preventing
material damage" → Page 11 sec-
tions to ensure that you use the
appliance safely.
¡ Keep the transit bolts, screws and
sleeves in a safe place for future
"transport" → Page 55.
Place the appliance
on a water-resistant
wooden board which
is screwed tightly to
the floor. The wooden
board should be at
least 30 mm thick.
¡ A niche width of
60 cm is required.
¡ Only install the ap-
pliance under-
neath a continuous
worktop that is se-
curely connected
to adjacent cabin-
ets.
Do not trap the hoses
between the wall and
the appliance.
15