Electric Shock Hazard; Pressure Relief Valves - Graco 571169 Instructions Manual

Direct mount vent valve for g3 pumps
Table of Contents

Advertisement

Instructions
Instructions
Warnings
Also see the G3 Pump Instruction manual for additional
warnings.

ELECTRIC SHOCK HAZARD

This equipment must be
setup, or usage of the system can cause electric shock.
Turn off and disconnect power cord before servicing
equipment.
Connect only to grounded electrical outlets.
Use only 3-wire extension cords.
Ensure ground prongs are intact on power and
extension cords.
Do not expose to rain. Store indoors
SKIN INJECTION HAZARD
High-pressure fluid from dispense device, hose leaks, or
ruptured components will pierce skin. This may look like
just a cut, but it is a serious injury that can result in
amputation. Get immediate surgical treatment.
Follow Pressure Relief Procedure in this manual,
when you stop dispensing and before cleaning, check-
ing, or servicing equipment.
2
grounded.
Improper grounding,

Pressure Relief Valves

The pressure relief valve
uses a pressure adjustment
screw (a) to set the pres-
sure release point. It is not
intended as a way to
relieve pressure during
normal operation but as a
protective measure in the
event there is an unin-
tended pressure increase in
the system.
NOTE:
Do not use this pressure relief valve as a means
of relieving pressure in day-to-day, normal cycle
operation. Use the pressure relief procedure
described on page 3 of this manual to relieve
pressure during normal cycle operation.
The pressure relief valve included in this kit can
only be used with the Graco G3 Pump. It is not
intended for use with any other products.
Factory set to 4000 psi (275.8 bar, 27.6 MPa).
The pressure adjustment screw (a) will require periodic
adjustments. Whenever the valve is set/adjusted (after
the set point is found) it is important to ensure that the
valve is not bottomed out and there is at least 1/2 turn of
adjustment remaining. This is determined by turning the
screw (a) 1/2 turn and then back turning it out again.
NOTE: Turning adjustment screw (a) clockwise,
increases pressure.
a
locking
nut
3A1963G

Advertisement

Table of Contents
loading

This manual is also suitable for:

24m47857117024m47925c65257117124m481 ... Show all

Table of Contents