Operating Instructions: Software Version 7.1; Supplied Accessories; Safety; Ce Marking - Isotech TTI 7 PLUS User Maintenance Manual/Handbook

OPERATING INSTRUCTIONS: SOFTWARE VERSION 7.1

SUPPLIED ACCESSORIES

1 Mains Cord
1 RS 232 Cable
1 Operating Instructions (English)
When unpacked, inspect for physical damage and report any defects immediately in writing, retaining packaging
materials for inspection. Before placing into service, ensure mains voltage is correct. Instruments are normally
supplied for 240Volts 50Hz. Other voltages may also be selected according to the chart in the Maintenance section.
Be sure to also change the fuse to the correct type and rating.

SAFETY

This apparatus is designated Safety class 1 as defined in the IEC publication 1010-1 (Amendment 1).

CE MARKING

This apparatus complies with the CE marking directive, 93/68/EEC, and is in compliance with the following standards:
Generic Emission Standard
Conducted Emissions
Radiated Emissions
Generic Immunity Standard
Conducted Immunity (Power Lines)
Conducted Immunity (Signal Lines)
Radiated Immunity
Electrostatic Discharge Immunity
Electrical Safety Standard

INSTALLATION

PLUS
The TTI 7 is designed to be either free bench-standing, or rack-mounted. The TTI 7
When connected to a mains supply, the mains cord provided with the equipment should be used, and connected only
to a mains supply with a suitable earth connection. Before connection to the mains supply ensure that the correct
voltage is set, and the fuse is of the correct rating.

MAINTENANCE

Normally no maintenance is required other than cleaning with a moist cloth. Avoid aggressive detergents or solvents.
CAUTION: Before any maintenance, repair, or exchange of parts or fuses, the instrument must be disconnected
from the mains supply and all other power sources. In the event of a fault occurring, the instrument should be
returned to our factory, or Agent, for rectification. A mains fuse is fitted to the mains inlet socket on the rear panel,
and should be replaced if necessary. The Instrument should only be serviced/repaired by a competent engineer and
only design approved replacement parts used.
EN5081-1
EN55022 Class B
EN55022 Class B
EN5082-1
prEN60 1000-4-4 1kV
prEN60 1000-4-4 500V
prEN60 1000-4-3 3V/m
prEN60 1000-4-2 8kV
IEC1010-1 (Amend 1)
Page 6 of 44
PLUS
is ½19", 2.5U high.
TTI-7 Iss.02 – 06/11