Isotech TTI 7 PLUS User Maintenance Manual/Handbook page 26

CONFigure:TEMPerature:RTD <type>,<standard>,<con>,<current mode>,<root 2>
Sets the selected channel for an RTD measurement according to the following parameters.
type
< >
standard
< >
con
< >
current mode
< >
root 2
< >
Terminates the current measurement cycle and scanning routine.
Sets the scanner and data logger modes to OFF.
CONFigure?
Used to query the current configuration. The response is an ASCII string of either of the following forms:
channel ,<type>,<rj mode>,<ext rj mode>"
"< >,TC
channel ,<type>,<standard>,<con>,<current mode>,<root 2>"
"< >,RTD
Parameter values are as per the tables above. Does not affect the current measurement.
MEASure Group
These work similarly to the CONFigure commands, except that an immediate measurement is performed with the
result being sent to the output buffer. SINGle mode is set, and only one reading is taken. As with CONFigure, the
current measurement cycle will be aborted.
MEASure:TEMPerature:TC? <
MEASure:TEMPerature:RTD? <
MEASure:CHANnel? <
Parameters are as for the CONFigure command.
SENSe Group
SENSe:TEMPerature:UNIT
Sets the temperature units to be used in all responses.
<parameter>
SENSe:TEMPerature:UNIT?
Queries the temperature unit in force. Responds with "C", " F" or "K".
SENSe:TEMPerature:RESolution
Sets the temperature resolution to be used in all responses.
<resolution>
Pt25, Pt100
1 Invalid (Obsolete)
2 Invalid (Obsolete)
3 (EN60751)
4-23 (User Probe 1-20)
3, 4 (3 or 4 wire connectivity)
+I, -I, AVE
0, 1, Off, On
type>,<rj mode>,<ext rj standard>
type>,<standard>,<con>,<current mode>,<root 2>
channel>
<parameter>
C, F, K (degrees)
<resolution
>
1, 0.1, 0.01, 0.001 (degrees)
Page 26 of 44
TTI-7 Iss.02 – 06/11