Appendix I: Command Summary; Programming Language; Measurement Configuration Commands; Triggering Commands - Isotech TTI 7 PLUS User Maintenance Manual/Handbook

APPENDIX I: COMMAND SUMMARY

Programming Language

All interfaces use the same commands.
For the RS-232 interface these commands are sent as part of a serial string.
For the IEEE-488 interface these commands are sent as a Multi-wire Interface Message (with ATN=High).

Measurement Configuration Commands

CONFigure
channel>
:CHANnel <
<type>,<rj mode>,<ext rj standard>
:TEMPerature:TC
<type>,<standard>,<con>,<current mode>,<root 2>
:TEMPerature:RTD
CONFigure?
MEASure
<type>,<rj mode>,<ext rj standard>
:TEMPerature:TC?
<type>,<standard>,<con>,<current mode>,<root 2>
:TEMPerature:RTD?
<channel>
:CHANnel?
SENSe
<parameter>
:TEMPerature:UNIT
:TEMPerature:UNIT?
:TEMPerature:RESolution
:TEMPerature:RESolution?

Triggering Commands

INITiate
*TRG
function
FETCh[:< >]?
READ?
ABORT
TRIGger
SINGle/INFinite
:MODE <
:MODE?
:COUNt <n>
:COUNt <slx>, <n>
:COUNt?
:COUNt? <slx>
:DELay <hh:mm:ss>
:DELay <slx>, <hh:mm:ss>
:DELay?
:DELay? <slx>
:SAMPle:COUNt?
:SAMPle:COUNt? <slx>
:SAMPle:DELay <slx>, <hh:mm:ss>
:SAMPle:DELay? <slx>
<resolution>
>
Page 41 of 44
TTI-7 Iss.02 – 06/11