Outdoor Mounting (Optional)
Note: This document does not include installation
and service instructions for the AD outdoor
housing. These instructions are supplied with the
housing.
The camera dome attaches to outdoor walls and
ceilings using an AD outdoor housing (Figure 5)
and an ROENDC end cap connected to one of the
following optional mounting structures (Figure 7).
• RHOTR Over Roof Mount
• RHOTRF Over Roof Floor Mount
• RHOPN Pendant Mount
• RHOWPA Pole Mount
• RHOSW/RHOLW Wall Mount
• RHOWCA Corner Bracket.
The outdoor housing contains a pre-installed
mounting base, a cooling fan for hot weather, a
heater for cool weather and to prevent icing, and
surge protection circuitry.
An environmental PC board is used to pre-wire
cables. A round spring-finger connector on the
board makes electrical contact with the housing
and eyeball assembly as it connects to the base.
Note: Do not use the I/O board (designed for
indoor use) in place of the environmental board.
Figure 5. AD outdoor housing (optional)
SPEEDDOME ULTRA 8 CAMERA DOME
INSTALLATION AND SERVICE GUIDE
SpeedDome Housing Adapter
Bracket (Optional)
An RHSDA adapter bracket (Figure 6) enables the
dome to fit into SpeedDome indoor housings
(RD500A). Locking pins in the bracket enable the
dome to swing out for servicing or removal.
Figure 6. RHSDA adapter bracket
(used with the RD500A housing)
5 of 30
8200-0600-03, REV. B