American Dynamics SpeedDome Ultra 8 Installation And Service Manual page 24

Removing the Tilt Motor
1. Perform procedure "Removing the Slot Covers"
(page21).
2. Perform procedure "Removing the Camera"
(page 22).
3. Perform procedure "Detaching the Eyeball"
(page 22).
4. Separate the yoke brackets (Figure 27).
Figure 27. Separating the yoke brackets
5. Gently pry off the yoke bracket covering the pan
gear assembly to access the tilt cable assembly
(Figure 28).
Figure 28. Removing the yoke brackets
SPEEDDOME ULTRA 8 CAMERA DOME
INSTALLATION AND SERVICE GUIDE
6. Access the tilt motor.
To do this, loosen the captive retaining screw
holding the tilt cable assembly in place and
gently remove the assembly.
7. Remove the tilt motor (Figure 29).
Lift the motor housing up as shown to
disengage the motor from the tilt gear. Then pull
the motor bracket towards the outside of the
cable/tilt assembly to remove the motor.
Figure 29. Removing the tilt motor
8. Reverse the steps to reassemble.
CAUTION: When installing a new motor, be
careful to properly mesh the motor with the tilt
gears! Failure to do so can destroy both motor
and tilt gear. Verify the tilt gear turns freely.
24 of 30
Tilt Motor
(Lift up, then out.)
8200-0600-03, REV. B